I had a red NSX trailing me near Kingman, AZ. As we entered RTE 93 from 60 we both gunned it and went side by side off the ramp. I was able to hold next to him until about 85-90mph, then he pulled away (I didn't even expect to be with him that long) with a wave and a sarchastic little chuckle. Anyone know this punk?

Off topic...I need some assistance with my B&M shifter. I am having trouble getting it into 5th and 6th gear. I lined up the plate with the reverse pin (as instructed) and all gears are free-flowing with the car idle. Anyone ever have this problem? Also, it rattles like a SOB. I am ready to take the damn thing out. Maybe a topic for the next tech session?

 

Let me see what I can find. Alot of people with the B&M short shifters were having problems. I think some were saying it was the design of the plate and others were saying it was just problems with the shifter itself. I'll look into it.

 

Check out this thread over on Motoring:

http://www.350zmotoring.com/forums/s...=short+shifter

You might check this one also:

http://www.350zmotoring.com/forums/s...=short+shifter

and one last one:

http://www.350zmotoring.com/forums/s...=short+shifter

 

Thanks ZRO.

 

I just put the B&M shifter in too and had similar problems. I took out the rubber o ring and it fixed it. It doesn't rattle either. Also, did you grind down the piece of the tunnel like the directions told you to? Another comment: I have a 350EVO shifter in my garage if you are interested.

 

Yeah, I filed out about 1/8" in the UL corner. Which rubber o-ring? I may be interested in your EVO shifter if I can't sort this out.

 

I forget where it went exactily, but I think its between the blue plate and something else.