Didnt pass smog!!! need help!
#28
and here me doing a 82 ecu swap into my 79. hahahahah im behind the times, when you guys do this stuff you should do a write up and post it, cause stuff like that is super handy, but i dont know every detail.
#30
just remove the kick panel over the ecu so you can reach the wires with your hands.
Remember that this stuff is old and plastic so don't yank it hard or out of frustration.
Usually it's the two connectors with the smaller pin type terminals....just a slight wiggle while it's running will tell you if that's a problem.
Remember that this stuff is old and plastic so don't yank it hard or out of frustration.
Usually it's the two connectors with the smaller pin type terminals....just a slight wiggle while it's running will tell you if that's a problem.
#31
Originally Posted by PooFlinginMonke
just remove the kick panel over the ecu so you can reach the wires with your hands.
Remember that this stuff is old and plastic so don't yank it hard or out of frustration.
Usually it's the two connectors with the smaller pin type terminals....just a slight wiggle while it's running will tell you if that's a problem.
Remember that this stuff is old and plastic so don't yank it hard or out of frustration.
Usually it's the two connectors with the smaller pin type terminals....just a slight wiggle while it's running will tell you if that's a problem.
Thread
Thread Starter
Forum
Replies
Last Post
ablang
300ZX (Z31) Forums
2
04-08-2013 09:31 PM
Bookmarks