300ZX (Z31) Performance / Technical Discussions related to Turbo charging, Supercharging, Engine, ECU, exhaust, and etc. performance enhancements and Techical related.

Help me, new to this site and a Z newby

Thread Tools
 
Search this Thread
 
Old 06-01-2006 | 05:48 AM
  #1  
Fanta-Z's Avatar
Thread Starter
Registered User
 
Joined: Jun 2006
Posts: 2
From: South Florida baby ! part where the heat is on !
Help me, new to this site and a Z newby

I had just purchased an 85 300zx NA 2+2 with 123,000 miles. I drove the car for 3 weeks, the car has new wires, plugs, fuel filter, and timing belt. I got home the other night and went in for dinner, came out, started the car up, she ran really rough, coughing, then stalls. My experience with my 82 corvette, I went for the Air Flow Meter and Disconnected it, the car fired right up, but you couldn't rev above 2000 RPM, Would this be a symptom of a bad Air Flow meter ? The car was idling and you could rev it with the unplugged Air Flow Meter but not over 2000 RPM , she seemed to run fine ??
Old 06-01-2006 | 09:33 AM
  #2  
entropy31's Avatar
The Cake Is A Lie!
 
Joined: May 2003
Posts: 5,690
From: WA
sounds right. unplugged MAS will limit you to 2000 rpm.
Old 06-01-2006 | 11:16 AM
  #3  
Fanta-Z's Avatar
Thread Starter
Registered User
 
Joined: Jun 2006
Posts: 2
From: South Florida baby ! part where the heat is on !
So it is a bad air flow meter, I did disconect it, and the car ran better
Old 06-01-2006 | 01:44 PM
  #4  
entropy31's Avatar
The Cake Is A Lie!
 
Joined: May 2003
Posts: 5,690
From: WA
Originally Posted by Fanta-Z
So it is a bad air flow meter, I did disconect it, and the car ran better
very likely, yes.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
GetStiggyWithit
FS: 300ZX (90-96)
4
07-18-2011 10:50 AM
DSR300zx
300ZX (Z32) Appearance Exterior, Interior
3
05-27-2006 09:44 AM
shezzzhot
The Lounge (Off Topic)
6
03-14-2006 10:28 PM
KPlus300ZX
The Lounge (Off Topic)
8
09-08-2005 09:38 AM



Quick Reply: Help me, new to this site and a Z newby



All times are GMT -7. The time now is 11:06 AM.