RollinaZx

Just bought a 93 300zx and am having trouble getting off the nose center panel. Can someone diagram where the screws are holding it down I see where two are but would I have to take off the front bumper to get to the 2nd set of screws?

bartZ32

absolutely not. really really simple, just remove the two bolts on the top corners.

RollinaZx

I was only taking out the outer bolts, Hey do you know how much horsepower a better intake would add, only like 5-15 right?

NismoPick

Clicky: https://www.zdriver.com/forums/300zx-z32-tech-tips-273/how-make-n-faster-swap-mass-merge-thread-658/

CanyonCarver

There are four bolts. Two on the plastic and two holding the metal bracket towards the center of the panel. Then there are for rubber grommets holding the lower part in, so you have to wiggle the panel out.

96z32(racer)

does anyone know where i can get this nose panel at? it has the straight whole across the whole thing for air induction. looks like its bout a inch or so up and down and then the whole thing across?