NA - TT Z32 Build up
#1
NA - TT Z32 Build up
HE HE and what I talked about doign not so long ago finally begins. Today the EFi harness was removed and teh Engine is about to be droped. wish me luck guy's and I'm open for alot of adivce. on anithing.
#6
I aint got a digital camera. and my Phone was taken away @ school by a dick head teacher/ security guard. I'll buy one though guy's don't worry. and for the write up I'll use spell check ofcourse.
#10
OK I'm still working on pulling the motor out and straighting out my frame. I need hella lotta pictures on teh Front end of teh car. specially on teh Upper suppodrt rail for teh radiator. if you guys can lay down a 2x4 or something really straight on it so i cna see how much it curves and stuff. thnx yo!
#11
Originally Posted by bardabe
OK I'm still working on pulling the motor out and straighting out my frame. I need hella lotta pictures on teh Front end of teh car. specially on teh Upper suppodrt rail for teh radiator. if you guys can lay down a 2x4 or something really straight on it so i cna see how much it curves and stuff. thnx yo!
#13
Originally Posted by bardabe
no just a few dings btu i wanna get it like close to perfection
#14
Originally Posted by CanyonCarver
You can put in a new radiator support and be perfect. I'm doing that on a civic right now. the new part was $70. Remove all of the attachments, drill out spot welds till material seperates, remove old, install new and re-tach weld at the old spot welds, then paint. good as new. I prepainted the support so I only have to touch up at the welds.
#15
If the body frame is bent I would try to find a really cheap z32 with a straight frame and a blown or no motor. You'll have a front clip anyway. It's hard to get the frame aligned perfectly back to spec. If it were me that's what I would do and salvage what parts you can off your wrecked Z.
#19
Originally Posted by bardabe
Well here are the pictures of mah frame.
#20
Originally Posted by CanyonCarver
YUUUUUPPPP, that's the radiator support....... the piece that goes all the way across the front. Just replace it. They're usually only spot welded on.
#21
Originally Posted by bardabe
well im not a good welder for this kinda stuff so how much am I lookign @ for a shop to replace if I buy teh piece?
#22
well considering that my dad told me he was gonna go pick up the Jerry pickeraka engine lift. and instead bought a new living room set. all ghood everihing is comign along great more pictures to come soon. when the ingene is ready for the harvesing. havent worked on it for days now.
#25
MOTOR COMES OUT TODAY!!!! I'm going over to nissan to se if they have the engine slingers. last minute convenience btu if it does come out today!!! pictures I will post in the adter noon. WISH ME LUCK GUYS!!!!