The official post whore thread..
#7751
are these bolts and a new gasket are all i need to change my intake/exhaust gasket?
http://www.thezstore.com/page/TZS/PROD/PEC05/15-8081
http://www.thezstore.com/page/TZS/PROD/PEC05/15-8081
#7754
****!!!! is finding the bolt spacing on a z32 rear caliper so ****ING difficult!!! holy ****ing **** batman, why doesnt the ****ing factory ****ing service ****ing manual have stupid **** like this? jesus ****ing christ!!!!! and you can **** off if you thing im gonna ****ing capitalize jesus's ****ing name......holy ****.........
/vent
/vent
#7756
deal, just remember to measure from the center of the hole to the center of the hole. on the mounting tabs of the calipers.
Last edited by hoov100; 03-22-2009 at 08:29 PM.
#7758
#7764
alright. i'll just take both measurements that i think you may be referring too. the picture says the spacing of caliper holes, and a previous post says spacing of where it mounts to the spindle. maybe i'll see when i get out there.
#7775
lol wow. ^^^^
If I had the need for a daily (I walk to work) I'd probably get something I wouldn't even tell anyone about. You know, one of those cars you run into the side rails for fun. Something I can run into a telephone pole with, fold the radiator in half, drive until it overheats, blows a gasket, looses oil pressure, shoots a rod through the hood, then get out and laugh at it. One of those cars.
If I had the need for a daily (I walk to work) I'd probably get something I wouldn't even tell anyone about. You know, one of those cars you run into the side rails for fun. Something I can run into a telephone pole with, fold the radiator in half, drive until it overheats, blows a gasket, looses oil pressure, shoots a rod through the hood, then get out and laugh at it. One of those cars.